Setting The Time And Day; Accepting The Preset Programmes - Kingspan KHP0041 Installation And Maintenance Manual

7 day hot water programmer
Setting the correct Time and Day
These settings are made during anufacture and only need
to be made in the unlikely event that the unit has lost the
settings.
Setting the Date
Press and hold PROG for 5 seconds to display year.
Use the + or - buttons to set the correct year.
Press DAY/HOL to display day and month. Use the + or -
Press DAY/HOL to display day and month. Use the + or -
buttons to set day of month.
Press PROG to display the time.
The words SET TIME will appear at the top of the display &
the time will fl ash on and off .
Use the + or - buttons to set the correct time (press and
hold to change in 10 min. increments).
Setting the Day
The day of the week is set automatically.

Accepting the preset programmes

If you are happy to use the preset programmes on page 46,
you don't need to do anything else.
To accept the factory presets just press the PROG button
once until the time appears and colon in the display
begins to fl ash.
Before you change the preset programmes
Your installer will have set your unit to operate in one of the
following modes:
another for weekends (page 48)
(page 49)
(page 50)
Please Note
If you want to leave a preset time as it is, simply press NEXT to move on to the next setting.
Your unit is now in RUN mode and will control your heating
and hot water according to the preset programmes.
See INSTALLER SETTING tick box on inside
flap label to ascertain which mode your unit
is set.
DAY/HOL
37