Table of Contents
Advertisement
a
b
Note
‡
If you are not going to use the remote control for a
long time, remove the batteries.
‡
Do not use old and new or different types of batteries
in combination.
‡
Batteries contain chemical substances, so they should
be disposed of properly.
Set clock
1
In standby mode, press and hold CLOCK
for over 3 seconds.
» [12HR] or [24HR] begins to blink.
2
Press + VOL - repeatedly to select 12/24
hour format, and then press CLOCK to
FRQÀUP
» The hour digits are displayed and begin
to blink.
3
Press + VOL - repeatedly to set hour, and
then press CLOCK WR FRQÀUP
» The minute digits are displayed and
begin to blink.
4
Repeat step 3 to set minute.
c
Activate demonstration mode
You can see an overview of all features.
,Q VWDQGE\ PRGH ZLWK FORFN GLVSOD\ LI VHW SUHVV
to activate the demonstration mode.
» A demonstration of major available features
starts.
‡
To deactivate the demonstration mode,
press
again.
Turn on
Press .
» The unit switches to the last selected
source.
Switch to Eco Power standby mode
Press and hold
for over 3 seconds to switch
the unit to Eco Power standby mode.
» The backlight on the display panel turns off.
» The red Eco power indicator turns on
To switch the unit to standby mode:
In Eco Power standby mode, press and hold
for over 3 seconds.
» 7KH FORFN LI VHW DSSHDUV RQ WKH GLVSOD\
panel.
» The red Eco Power indicator turns off.
Tip
‡
If the system remains in standby mode for more
than 90 seconds, it switches to the Eco Power mode
automatically.
Find the correct viewing
channel
1
Press
to turn on the unit.
2
Press DISC to switch to disc mode.
EN
13
Advertisement
Table of Contents
