Prepare The Remote Control; Set Clock; Turn On; Switch To Standby Mode - Philips MCM770 User Manual

1
Prepare the AC adaptor.
2
Connect one end to the DC IN socket on
the main unit.
3
Connect the other end to the wall outlet.

Prepare the remote control

Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine or fi re. Never discard batteries in fi re.
For fi rst-time use:
1
Remove the protective tab to activate the
remote control battery.
To replace the remote control batteries:
1
Open the battery compartment.
2
Insert one lithium CR2025 battery with
correct polarity (+/-) as indicated.
3
Close the battery compartment.
Note
•
Before pressing any function button on the remote
control, fi rst select the correct source with the remote
control instead of the main unit.
•
If you are not going to use the remote control for a
b b
long time, remove the battery.

Set clock

1
In the standby mode, press and hold
CLOCK to enter the clock setting mode.
The hour digits are displayed and begin
»
to blink.
If the hour digits are not displayed,
»
c c
press and hold
seconds to switch to standby mode,
then repeat step 1.
2
Press + VOL - to set the hour.
The minute digits are displayed and
»
begin to blink.
3
Press + VOL - to set the minute.
4
Press CLOCK to confi rm the clock setting.

Turn on

1
Press
The audio system switches to the last
»
selected source.

Switch to standby mode

1
Press
Power Standby mode.
for more than 2
.
to switch the audio system to Eco
EN
13