Get Started; Prepare The Remote Control; Set Clock; Turn On - Philips MCD388/12 User Manual

4 Get started

Caution
•
Use of controls or adjustments or
performance of procedures other than herein
may result in hazardous radiation exposure or
other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
back of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________

Prepare the remote control

Caution
• Risk of explosion! Keep batteries away from
heat, sunshine or fire. Never discard batteries
in fire.
For first-time use:
1
Remove the protective tab to activate the
remote control battery.
To replace the remote control batteries:
1
Open the battery compartment.
2
Insert one lithium CR2025 battery with
correct polarity (+/-) as indicated.
3
Close the battery compartment.
Note
•
Before you press any function button on the
remote control, first select the correct source
with the remote control instead of the main
unit.
18 EN

Set clock

1
In the Eco Power standby mode, press
and hold CLOCK on the front panel to
activate the clock setting mode.
»
The hour digits are displayed and begin
to blink.
2
Press + VOL - to set the hour.
»
The minute digits are displayed and
begin to blink.
3
Press + VOL - to set the minute.
4
Press CLOCK to confirm the clock
setting.

Turn on

1
Press .
»
The unit switches to the last selected
source.
2
Wait for automatic setup of wireless
connection between the main unit and
subwoofer.
» [PAIRING] (pairing) flashes.
»
If the connection succeeds,
(pair OK) and
the blue indicator on the subwoofer
lights up.
»
If the connection fails,
(pair fail) is displayed and the green
indicator on the subwoofer lights up.
»
If the wireless connection fails, set up
the connection manually.
Set up wireless connection manually
1
In the Eco Power standby mode, press
and hold on the main unit for 3
seconds.
» [PAIRING] (pairing) flashes.
2
Press and hold PAIR on the subwoofer
for 3 seconds.
[PAIR OK]
are displayed and
[PAIR FAIL]