Get Started; Prepare The Remote Control; Auto Install Radio Stations; Set Clock - Philips MCD170/12 User Manual

4 Get started

Caution
•
Use the controls only as stated in this user manual.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of your DVD Micro
Theater. The model number and serial number
are on the rear of your DVD Micro Theater.
Write the numbers here:
Model No. __________________________
Serial No. ___________________________

Prepare the remote control

Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine or fi re. Never discard batteries in fi re.
For fi rst-time use:
1
Remove the protective tab to activate the
remote control battery.
To replace the remote control battery:
1
Open the battery compartment.
2
Insert 1 CR2025 battery with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
14 EN
Note
•
Before pressing any function button on the remote
control, fi rst select the correct source with the
remote control instead of the main unit.
•
If you are not going to use the remote control for a
long time, remove the battery.

Auto install radio stations

When you connect the DVD Micro Theater to
the power supply for the fi rst time, or no radio
station is stored in this DVD Micro Theater, Plug
and Play is activated to store all available radio
stations automatically.
1
Connect the DVD Micro Theater to the
power supply.
2
Press on the main unit to start
installation.
»
[AUTO] (auto) is displayed.
»
The DVD Micro Theater automatically
store radio stations with suffi cient
signal strength.
»
When all the available radio stations
are stored, the fi rst preset radio station
is broadcast automatically.

Set clock

1
Press and hold CLOCK/DISPLAY to
activate the clock setting mode.
»
The 12 hour or 24 hour format is
displayed.
2
Press PROG repeatedly to select 12 hour
or 24 hour format.
3
Press CLOCK/DISPLAY to confi rm.
»
The hour digits are displayed and begin
to blink.
4
Press / to set the hour.
5
Press CLOCK/DISPLAY to confi rm.
»
The minute digits are displayed and
begin to blink.