Get Started; Prepare The Remote Control; Set Clock; Turn On - Philips MCD388/55 User Manual

4 Get started

Caution
•
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
back of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________

Prepare the remote control

Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine or fi re. Never discard batteries in fi re.
For fi rst-time use:
1
Remove the protective tab to activate the
remote control battery.
To replace the remote control batteries:
1
Open the battery compartment.
2
Insert one lithium CR2025 battery with
correct polarity (+/-) as indicated.
3
Close the battery compartment.
Note
•
Before you press any function button on the remote
control, fi rst select the correct source with the remote
control.
•
If you are not going to use the remote control for a
long time, remove the battery.

Set clock

1
In the standby mode, press and hold
CLOCK on the front panel to activate the
clock setting mode.
The hour digits are displayed and begin
»
to blink.
2
Press + VOL - to set the hour.
The minute digits are displayed and
»
begin to blink.
3
Press + VOL - to set the minute.
4
Press CLOCK to confi rm the clock setting.

Turn on

1
Press .
The unit switches to the last selected
»
source.
2
Wait for automatic setup of wireless
connection between the main unit and
subwoofer.
» [PAIRING] (pairing) fl ashes.
If the connection succeeds,
»
(pair OK) and
the blue indicator on the subwoofer
lights up.
If the connection fails,
»
(pair fail) is displayed and the green
indicator on the subwoofer lights up.
If the wireless connection fails, set up
»
the connection manually.
[PAIR OK]
are displayed and
[PAIR FAIL]
EN 17