Get Started; Install Remote Control Batteries; Set Clock; Activate Demonstration Mode - Philips mcd909 User Manual

4 Get started

Caution
•
Use of controls or adjustments or
performance of procedures other than herein
may result in hazardous radiation exposure or
other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
back of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Install remote control
batteries
Caution
• Risk of explosion! Keep batteries away from
heat, sunshine or fire. Never discard batteries
in fire.
• Risk of decreased battery life! Never mix
different brands or types of batteries.
•
Risk of product damage! When the remote
control is not used for long periods, remove
the batteries.
a
1
Open the battery compartment.
2
Insert two AAA batteries with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
b c

Set clock

1
In standby mode, press and hold RDS/
CLOCK to activate the clock setting
mode.
»
The hour digits are displayed and begin
to blink.
2
Turn VOLUME+/- to set the hour.
3
Press RDS/CLOCK to confirm.
»
The minute digits are displayed and
begin to blink.
4
Turn VOLUME+/- to set the minute.
5
Press RDS/CLOCK to confirm.

Activate demonstration mode

You can see an overview of all features.
1
In standby mode, press
unit to activate the demonstration mode.
»
A demonstration of major available
features starts.
To deactivate the demonstration mode:
1
Press on the main unit again.

Turn on/off decoration light

1
Press DIM to turn on/off the main set
decoration light.

Turn on

1
Press .
»
It takes 10 seconds to heat up before
the apparatus turns on.
on the main
EN 17