DEFAULT SETTINGS: Restore all the settings to factory settings.
17. PTZ SETUP
Move the cursor to 【PTZ SETUP】 (Icon highlighted when selected), press 【Enter】 to access the setting
interface. You can setup the parameters for each channel separately.
CHANNEL: The channel with PTZ connected.
PROTOCOL: Select the protocol for the PTZ, there are two protocols to select. The default is Pelco-D.
BAUD RATE: Select the baud rate for your PTZ, the options are 1200, 2400, 4800, and 9600.
DATA BIT: There are 5, 6, 7, 8 options to select. The default setting is 8.
STOP BIT: Two options to choose from: 1and 2. The default setting is 1.
VERIFY: Options: None / Odd / Even / Mark / Space to choose from. The default setting is None.
ADDRESS: Fill in the code of respective PTZ.
21