Step 2: Configuring The Netgear Prosafe Vpn Client On The Remote Pc - NETGEAR DG834 Reference Manual

To view or modify the tunnel settings, select the radio button next to the tunnel entry and click
Edit.
Note: Refer to
the IKE keep-alive capability on an existing VPN tunnel.
Step 2: Configuring the NETGEAR ProSafe VPN Client on the
Remote PC
This procedure describes how to configure the NETGEAR ProSafe VPN Client. We will assume
the PC running the client has a dynamically assigned IP address.
The PC must have the NETGEAR ProSafe VPN Client program installed that supports IPSec. Go
to the NETGEAR website (http://www.netgear.com) and select VPN01L_VPN05L in the Product
Quick Find drop-down menu for information on how to purchase the NETGEAR ProSafe VPN
Client.
Note: Before installing the NETGEAR ProSafe VPN Client software, be sure to turn off
any virus protection or firewall software you may be running on your PC.
1. Install the NETGEAR ProSafe VPN Client on the remote PC and reboot.
• You may need to insert your Windows CD to complete the installation.
• If you do not have a modem or dial-up adapter installed in your PC, you may see the
warning message stating "The NETGEAR ProSafe VPN Component requires at least one
dial-up adapter be installed." You can disregard this message.
• Install the IPSec Component. You may have the option to install either the VPN Adapter
or the IPSec Component or both. The VPN Adapter is not necessary.
• The system should show the ProSafe icon (
• Double-click the system tray icon to open the Security Policy Editor.
2. Add a new connection.
• Run the NETGEAR ProSafe Security Policy Editor program and, using the
Configuration Worksheet" on page
Virtual Private Networking (Advanced Feature)
Reference Manual for the ADSL Firewall Router DG834
"Using Auto Policy to Configure VPN Tunnels" on page 7-36
7-7, create a VPN Connection.
v2.0, September 2005
) in the system tray after rebooting.
to enable
"VPN Tunnel
7-11