Fru Tests - ThinkPad Z61e Hardware Maintenance Manual

Indicator
10
Standby status
11
Ultrabay
Enhanced status

FRU tests

The following table shows the test for each FRU.
FRU
System board
Power
LCD unit
Modem daughter card
(MDC-1.5)
Audio
Speaker
(continued)
Meaning
Green:
The computer is in standby mode.
Blinking green:
The computer is entering standby mode or hibernation
mode, or is resuming normal operation.
Green:
An Ultrabay Enhanced device is installed and in use.
Blinking green:
An Ultrabay Enhanced device is in the process of being
detached.
Turn off:
An Ultrabay Enhanced device is ready to be attached or
detached.
Note: If you are using Windows 2000, the Ultrabay Enhanced
status indicator does not blink while an Ultrabay Enhanced
device is being detached. Instead, a message box pops up when
the process is completed; then the indicator turns off.
Applicable test
1. Diagnostics --> CPU/Coprocessor
2. Diagnostics --> Systemboard
3. If the docking station or the port replicator is attached to the
ThinkPad computer, undock it. Place the computer on a
horizontal surface, and run Diagnostics --> ThinkPad Devices
--> HDD Active Protection Test.
Note: Do not apply any physical shock to the computer while
the test is running.
Diagnostics --> ThinkPad Devices --> AC Adapter, Battery 1 (
Battery 2)
1. Diagnostics --> Video Adapter
2. Interactive Tests --> Video
1. Make sure the modem is set up correctly.
2. Replace the modem jack and the modem card in turn, and run
the following tests in Diagnostics --> Communication:
a. Conexant Smart Modem Interrupt
b. Conexant Smart Modem Dialtone
1. Interactive Tests --> Internal Speaker
2. Enter the BIOS Setup Utility and change Serial ATA (SATA)
setting to Compatibility, and run Diagnostics --> Other
Devices --> Analog Devices HDA CODEC Test
Interactive Tests --> Internal Speaker
Product overview
ThinkPad Z61e, Z61m, and Z61p
39