Table of Contents
Advertisement
AXIS 2191 Installation Guide
Installing the Audio Module
Follow the guide below to quickly get your AXIS 2191 up and running. Refer to the illustrations on
the previous page for connector details.
Before you start the installation of the AXIS 2191 Audio Module, you must first install your
network camera. To do this, please refer to the documentation supplied with your camera. If you
intend running the audio module in full-duplex mode, check that the sound card on your computer
supports this.
If using an external microphone, connect it to
the socket provided. To use an alternative input
device, (e.g. CD-player or radio) connect it to
Line-In on the terminal block.
Set the selector switch
to Ext to use an external
microphone or device.
Otherwise, set to Int to use
the internal microphone.
Using the supplied cable, connect the
audio module's serial port to the network
camera's serial port.
Connect power
to the audio module.
Check that the power indicators on both the audio module and the
camera are lit. Note that the power LED will blink during power-up.
Using a screwdriver,
adjust the Volume In con-
trol so that the Level In
LED occasionally shows
yellow, but not red.
To verify the connection to the AXIS 2191,
start Internet Explorer and enter the IP address
of the network camera in the location/address
field, e.g. 171.1.2.200, as shown here. Configure
the audio module from the camera's adminis-
tration pages, as described in the following
section.
Connect a loudspeaker to the 3.5mm socket (amplified speakers
only), or to Out on the terminal block (speakers with no amplifica-
tion). Other devices (including headphones) are connected to the
terminal block.
Page 3 of 7
Advertisement
Table of Contents
