Troubleshooting; No Voltage With The Key In The “On” Position; Battery Removal; Battery Inspection - Gilera Nordwest Workshop Manual

WARNING
The electrolyte level must be checked periodically; top up with distilled water if
necessary.
Remove the battery from the frame when charging.
Keep battery away from sparks and flames due to the hydrogen produced by
the battery.
All charging components may be tested without removal.

TROUBLESHOOTING

No voltage with the key in the "ON" position:
Dead battery.
Disconnected battery cable.
Main fuse blown.
Defective ignition switch.
Low voltage with the key in the "ON" position:
Weak battery.
Battery incorrectly connected.
Defective charging system.
Low voltage with engine on:
Insufficiently charged battery.
Malfunction in the charging circuit.

BATTERY REMOVAL

Remove seat.
Remove the battery securing rubber band.
Disconnect the battery's negative (-) and then positive (+) terminals.
Remove the battery.

Battery inspection

Check each element with a hydrometer.
Specific gravity: 1,270 ÷ 1,290 at 20°C.
If the specific gravity is under 1,230 the battery must be charged; specific
gravity varies according to temperature.
Replace battery if there is sulfation and if the space between the plates is full
of sediments.
Note:
The battery's electrolyte contains sulphuric acid.
Always protect they eyes, skin and clothes. If electrolyte gets in the yes, flush
thoroughly with water and seek expert medical advice.
16 - 2,1