Schwank 4BN6-CB-24 Installation & Owner's Manual page 25

Sample Patio Set-up :
Dining patio with 3 zones. Each zone has 2 opposing heaters that provide best comfort when op-
erating simultaneously as a pair. The entire patio area will be controlled by one Hand Set Trans-
mitter.
Set all 'House Codes' to the same Letter Code
on one Hand Set Transmitter and six receivers
(one in each heater). Heaters H-1 & H-2: Set
receiver Unit Codes to " 1 " - the hand set trans-
mitter will activate both heaters in Zone 1 with
Group I / Button 1 .
Similarly, set receivers in heaters H-3 & H-4 to
" 2 " and H-5 & H-6 to " 3 ". Both Zone 2 heaters
turn On/Off with button set " 2 " and both heat-
ers in Zone 3 with button set " 3 ".
Alternately, for individual control of heaters,
set each receiver Unit Code to a unique number ( H-1 to " 1 ", H-2 to " 2 ", etc.). Heaters H-1 to H-4
will be controlled by hand set transmitter Group I - Buttons 1 to 4 and heaters H-5 and H-6 will
be controlled by Group 2 - Buttons 1 and 2.
Kits / Part Numbers for Remote Control systems:
NOTE: Items are ordered separately
JP-1234-RK REMOTE CONTROL RECEIVER –

Typically Factory Installed - order as optional accessory

Can be ordered as a field installed Kit; Includes: receiver, wires, Velcro Fastener,

instructions
JP-1234-HS REMOTE CONTROL HAND SET – Accessory; single item with Velcro fas-

tener
Refer to the wiring diagram Section 14.1, Page 18.
All wiring should be done by a qualified electrician. The heater, when installed, must be electri-
cally grounded in accordance with local codes or, in the absence of local codes with the National
Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.1. All wiring and elec-
trical connection must conform to the requirements of the above codes. See Section 10, page 14.
NOTE: the ON/OFF switch may be removed from the heater for secure control of the heater using
the remote control hand set only. A rubber insert is supplied with the heater to fill the hole in the
control cover where the switch was mounted.
H-1
ZONE
1
1
H-2
25
H-3 H-5
ZONE ZONE
2 3
2 3
H-4 H-6
4BN/L6-24,4SN/L5 -24 Manual
RD: MAR, 2010
IM100310
RL: 1A - BA