Clearances To Combustibles - Outdoor Lifestyles Twilight-II-B Installation Manual

B. Clearances to Combustibles
When selecting a location for the appliance it is important
to consider the required clearances to walls (see Figure
3.2).
WARNING! Risk of Fire or Burns! Provide adequate
clearance around air openings and for service access.
Due to high temperatures, the appliance should be lo-
cated out of traffi c and away from furniture and draperies.
C*
Millimeters
Figure 3.2 Appliance Locations
Outdoor Lifestyles by Hearth & Home Technologies • Twilight-II-B Installation Manual • 2108-970 Rev. H • 5/14
GLASS
B
NOTE: Appliance may be installed flush on exterior, interior or
anywhere in between. Any projection of the appliance interior
or exterior must have a properly constructed chase surround-
ing the appliance. The exterior must have proper insulating,
flashing and finishing to ensure an insulated envelope.
WARNING! Risk of Fire! The exterior side of the TWILIGHT-II-B
CANNOT be recessed into the framing.
Refer to Section 8.A for mantel and wall projection information.
Consider the mantel or cabinet system to be installed and
comply with the necessary requirements for elevated hearth.
Refer to instructions included with cabinet system.
D
GLASS
C* = 24 INCH (MAX.)
GLASS
A B
Minimum Minimum Minimum
Inches 43 1/2
1092 13
* = C dimension may be any length from 0 to 24 inches.
NOTICE: Illustrations refl ect typical installations and are
FOR DESIGN PURPOSES ONLY. Illustrations/diagrams
are not drawn to scale. Actual installation may vary due to
individual design preference.
WARNING! Risk of Fire! The exterior side of the TWI-
LIGHT-II-B CANNOT be recessed into the framing.
GLASS
B
A
E
B
FLUSH TO EXTERIOR INSULATED ENVELOPE
C*
Maximum
0 24
0 610
EXTERIOR INSULATED ENVELOPE
C* = 0 INCH (MIN.)
FLUSH
TO INTERIOR
D E
Minimum -
36 43
914 1092
PROJECTION
9