Inserting And Removing Bobbins; Winding Bobbins And Its Adjustment - Consew Sewing Machine User Manual

THREAD
Cotton, synthetic or silk thread can be used according to your purpose, the thickness of
thread is up to # 8.
Left twist thread should be used in the needle, but either right or left twist thread can be
used in the bobbin.
In case of two needle machine, use right twist thread in the left needle for perfect
stitching.

INSERTING AND REMOVING BOBBINS

Push open the slide plate (1), (in case of two needle machine, left-hand and right-hand
plates). Pull up the latch (2) of the bobbin case and lift the bobbin (3) out of the bobbin
case.
To insert a full bobbin in the bobbin case, hold it between thumb and index finger of
your right hand. Place the bobbin on the center post of the bobbin case and push down the
latch (2).
Be sure that the thread draws out from the bobbin from left to right. Pull the thread into
the slot (4) and between the bobbin case opener (5) and the projection (6) and under the
tension spring (7).
Draw out about 5 mm of the thread on the needle plate and close the slide plate leaving
a sufficient space for passage of the thread.

WINDING BOBBINS AND ITS ADJUSTMENT

Push a bobbin on the bobbin winder spindle ( 1 ) as far as it 'vill go. Pass the thread
from the thread stand downward through the eye (7) in the tension bracket, then between
and around the back of the tension disc, bring the thread forward toward the bobbin and
wind from below in clockwise direction several times around the bobbin.
Push bobbin winder lever (3) downward until the wheel (2) contacts the drive belt and
then start the machine.
4