JVC SR- DVM600U Instructions Manual page 50

EDITING
50
EN
●
If the dubbing is paused while the channel is set to ADVB, you
cannot switch channels.
When you dub from DV equipment other than a
camcorder
A Perform steps 1 – 4.
B Locate the point from where you want to start dubbing,
then stop on the DV equipment.
●
If you pause the DV equipment in this step, a few
second's still picture will be recorded at the beginning of
the recorded program.
C Set the input mode to ADV INPUTB on the DV equipment.
●
If you select an input mode other than ADV INPUTB,
unwanted pictures may be recorded at the beginning of
the recorded program.
D Perform steps 9 – 12.
To skip unwanted part of the source picture
Press ENTER to stop both equipment, then press selection keys
to select .
Locate the point where you want to restart dubbing by pressing I,
N, or O, then press o.
Press selection keys to select
restart dubbing.
Recording Mode
MPEG2 format is used as recording format. As a guide for picture
quality, the AbpsB unit is used to represent how much data can be
recorded per second. The larger this value is, the better the picture
quality becomes but more capacity is required for the recording.
Select XP or SP for programs where quick movement occurs, such
as sports programs, and LP or EP for talk shows, etc. with
relatively less movement.
The recording modes for a 4.7 GB disc are set as follows:
Recording mode Recording amount
XP
SP
LP
EP
60-360
The amount varies
FR 420 depending on the
selected time.
480
●
For details on FR mode, refer to AFree Rate FunctionB on the
right column.
The recording modes for the HDD are set as follows:
Recording mode
XP
SP
LP
EP
FR480
●
For details on FR mode, refer to AFree Rate FunctionB.
NOTE:
The maximum recording time stated in the above table are the
approximate time under unused condition.
, then press ENTER to
Maximum recording
(approx.) time (approx.)
10 Mbps 1 hour
5 Mbps 2 hours
2.5 Mbps 4 hours
1.6 Mbps 6 hours
1 – 6 hours
7 hours
8 hours
Maximum recording time (approx.)
8 hours
16 hours
33 hours
49 hours
71 hours
Free Rate Function
To record the entire program, the unit automatically sets the
appropriate recording mode depending on the combination of the
total time of the program to be recorded and either the remaining
disc space or the specified recording time (from 60 minutes to 480
minutes).
8 To record the entire program within the actual remaining
disc space (DVD deck only)
Select AFR (JUST)B in a recording mode selection procedure.
●
Note that this function is available only when dubbing from HDD
to DVD (A pg. 45).
8 To record the entire program by specifying the desired
recording time
Select AFR60–FR360B, AFR420B or AFR480B in a recording mode
selection procedure.
8 To record a 25-min. long program five times on the same
DVD disc for example
Be sure to set the recording mode to AFR125B to fit the total
recording time to the whole disc space.
Blank
When the same program is recorded in SP mode instead of in
AFR125B, the 5th program cannot be recorded.
Blank
NOTES:
●
The maximum recording time of FR (JUST) mode is the same as
the recording time of FR480 mode. When dubbing a long
program in FR (JUST) mode on a disc whose remaining time is
short, it is recommended to check the disc remaining time in
FR480 mode to see if the remaining time is enough for the
program.
●
In order to ensure that the recording fits on the disc, this feature
may leave a slight non-recorded section at the end of the disc.
●
There may be some noise and sound disturbance at the point on
the disc where the unit switches the mode.
A: 1st
B: 2nd
C: 3rd
D: 4th
E: 5th
A: 1st
B: 2nd
C: 3rd
D: 4th
E: Blank (20 min.)