Installing Your New Recorder; Basic Connection - JVC HM-DR10000EU Instructions Manual

4
EN
Basic
Connection
Aerial terminal
Back of TV
21-pin SCART Cable
(provided)
Mains outlet
AV1 OUT switch
Mains power inlet
ATTENTION:
Your TV must have a 21-pin AV input connector (SCART) for
the connection to the recorder.
AV1 INPUT/OUTPUT SIGNAL SELECTION FOR AV CONNECTION
The AV1 IN/OUT connector accepts and delivers either a composite signal (regular video signal) or a Y/C signal (a signal in
which the luminance and chrominance signals are separated). For input signal selection, select "VIDEO" (regular video signal) or
"S-VIDEO" (Y/C signal) for "AV1 SELECT" setting (
If your TV's 21-pin AV input connector (SCART) is compatible only with the regular video signal, set this switch to COMP.
If your TV's 21-pin AV input connector (SCART) is compatible with the Y/C signal, set this switch to Y/C. You can obtain high-
quality S-VHS pictures. (For connection, be sure to use a 21-pin SCART cable that is compatible with the Y/C signal.)
NOTES:
Set your TV to the VIDEO (or AV), Y/C, or RGB mode according to the type of your TV's SCART connector.
For switching the TV's mode, refer to the instruction manual of your television.
To obtain high-quality S-VHS pictures, you can also use the S-VIDEO CONNECTION described on page 5.
21-pin SCART
connector
TV Aerial
Cable
RF Cable
(provided)
AV1 IN/OUT

INSTALLING YOUR NEW RECORDER

It's essential that your video recorder be properly connected.
Follow these steps carefully. THESE STEPS MUST BE COMPLETED
BEFORE ANY VIDEO OPERATION CAN BE PERFORMED.
CHECK CONTENTS
1
Make sure the package contains all of the accessories
listed in "Specifications" (
SITUATE RECORDER
2
Place the recorder on a stable, horizontal surface.
CONNECT RECORDER TO
TV
3
a– Disconnect the TV aerial cable from the TV.
b– Connect the TV aerial cable to the ANT. IN jack on
c– Connect the provided RF cable between the ANT.
d– Connect the provided SCART cable between the
e– Set the AV1 OUT switch to the appropriate position.
CONNECT RECORDER TO
MAINS
4
Connect the provided mains power cord between the
mains power inlet on the rear panel of the recorder and
a mains outlet.
After you plug the mains power cord into a mains outlet, the
Country Set display appears on the TV screen and/or on the
recorder's front display panel when the
recorder/remote control is pressed for the first time to power
on the recorder; go to page 6 to perform Auto Set Up.
Rear view
pg. 54). For output signal selection, use AV1 OUT switch of the rear panel.
pg. 82).
the rear panel of the recorder.
OUT jack on the rear panel of the recorder and the
TV's aerial terminal.
AV1 IN/OUT socket on the rear panel of the
recorder and the TV's 21-pin SCART connector.
See "AV1 INPUT/OUTPUT SIGNAL SELECTION FOR
AV CONNECTION" below.
button on the