Globe GFP500 Instruction Manual page 13

REASSEMBLY
1. Reinstall the hopper head by aligning the hinge with the base.
2. Secure the hopper head to the base.
a. GFP500 and GFP550 - Insert the hopper hinge pins into the hinge slots located on the base. Secure the
head by tightening the bottom hinge screw.
b. GFP700 and GFP750 - Line up the hopper head with the base and insert the hinge pin.
3. Place the ejector plate on the drive shaft. Turn plate until pin is properly aligned with the alignment pin on the
drive shaft.
4. Return the hopper head to its closed position.
Cleaning
Page 13