Globe GFP500 Instruction Manual page 10

CUBING/DICING DISCS
NOTE: When using the cubing/dicing discs always be sure to use the knife
with the matching sized grid or disc. Check the number imprinted on the
knife and back of the grid or disc for proper match.
NOTE: GFP700 and GFP750 - Make sure the cubing/dicing frame is in the
disc body correctly. The tab on the frame should lie against the rim of the
disc (Fig. 10-1).
1. Carefully hold the grid or disc (palm up) with sharp blades up.
2. Place the grid or disc on the drive shaft.
3. GFP700 and GFP750 only - Turn the disc until it falls into a locked position and the grid portion lines up with
the opening in the hopper head (Fig. 10-2).
4. Handle the knife by the thick side only and keep fingers away from cutting edge. Carefully place the
cubing/dicing knife with hub down onto the drive shaft (Fig. 10-3).
5. Carefully turn the knife until the drive pins line up with the slots on the knife hub and the knife is securely on the
drive shaft (Fig. 10-4).
GFP500 and GFP550
GFP700 and GFP750
Fig. 10-2
Page 10
Disc Installation and Removal
Fig. 10-3
Fig. 10-1
Fig. 10-4