Advertisement
W
iring diagram
Fig. D-2
Housing L side
Brush holder
on back side
Rear side
Fig. D-3
Put slacked Lead wire (purple) in these places.
Housing L
Brush holder
Fix the Lead wires with
Lead wire holder.
Choke coil
Fix the Field lead wire (red)
with the Lead wire holder on
Switch.
If the Equipment of Radio Interference suppression is required, put Noise suppressor and Choke coil
in the position drawn above.
Wiring of Field lead wires (orange), (purple) to Brush holder
Field
Housing R side
Side opening
Brush holder on Switch side
Switch
Connect Lead wires with Brush holders
as described below.
* Brush holder on switch side:
Face the Side opening to Housing R side.
* Brush holder on back side:
Face the Side opening to Housing L side.
Choke Coil
Pass all Field lead wires under
Brush holder. And connect
them to Switch.
Do not route the Field lead wire (Purple)
over Brush holder or rib for Switch but
route it between the ribs.
Noise suppressor
P 7/ 9
Advertisement
