LG LS-J0761CLCM Service Manual page 29

2) Connection of the cable
1. Remove the cover control from the unit by loosen-
ing the screw.
Connect the wires to the terminals on the control
board individually as the following.
1) Cooling only type
Terminals on the outdoor unit
Color of Wires
Color of Wires
Terminals on the indoor unit
2) Cooling & Heating type
Terminals on the outdoor unit
Color of Wires
Color of Wires
Terminals on the indoor unit
2. Secure the cable onto the control board with the holder
(clamper).
3. Refix the cover control to the original position with the
screw.
4. Use a recognized circuit breaker 16A between the power
source and the unit. A disconnection device to adequately
disconnect all supply lines must be fitted.
The length of the power supply cord should be over 1.8m measured from the power supply cord entry of the cabinet to the
middle of the live pin of the plug.
The power cord connected to the indoor unit should
be complied with the following specifications (Type
H05VV-F approved by HAR or SA).
2(N)
1(L)
BROWN BLUE GREEN/YELLOW
BROWN BLUE GREEN/YELLOW
1(L)
2(N)
2(N) 3 4
1(L)
BROWN BLUE BROWN BLUE G/Y G/Y BLACK BLACK RED
RED
G/Y BLACK RED
BROWN BLUE
BROWN BLUE G/Y RED
1(L)
2(N) 3 4
NORMAL CROSS-
SECTIONAL AREA
1.0mm
2
Outdoor unit
Over
5mm
Terminal block
(Pillar terminal)
Holder for
power supply
cord
Cover control
Connecting cable
LS-J0964HL
The connecting cable connected to the indoor and
outdoor unit should be complied with the following
specifications (Rubber insulation, type H07RN-F
approved by HAR or SA).
-29-
Terminal block
(Pillar terminal)
Connecting
cable
Holder for
connecting
cable
Cover control
LS-J0761HL/CL
LS-J0821CL
LS-J0962CL
Outdoor unit
Over 5mm
NORMAL CROSS-
SECTIONAL AREA
1.0mm
2