FIRM_UPGRADE_AUTO
Value Format
Description
Value Range
Default Value
Web User Interface Reference
FIRM_FILE_PATH
Value Format
Description
Value Range
Document Version
2013-02
Boolean
Specifies whether to display a confirmation message asking the user
to perform a firmware update (manual) or perform the firmware update
without asking the user (automatic) when the unit detects a newer
version of firmware.
Note
•
This setting is available only when
"FIRM_UPGRADE_ENABLE" is set to "Y".
•
Changing this setting may require restarting the unit.
•
Y (Enable automatic firmware update)
•
N (Disable automatic firmware update)
Y
Update Type (Page 124)
String
Specifies the URL where the firmware file is stored.
Note
•
This setting is available only when
"FIRM_UPGRADE_ENABLE" is set to "Y".
•
Changing this setting may require restarting the unit.
Max. 255 characters
Note
•
The format must be RFC 1738 compliant, as follows:
"<schema>://<user>:<password>@<host>:<port>/<url-path>".
–
"<user>" must be less than 64 characters.
–
"<password>" must be less than 64 characters.
–
"<user>:<password>@" may be empty.
–
The total of "<schema>://" and "<host>:<port>/<url-path>"
must be less than 128 characters.
–
":<port>" can be omitted if you do not need to specify the
port number.
•
If "{mac}" is included in this URL, it will be replaced with the
unit's MAC address in lower-case.
•
If "{MAC}" is included in this URL, it will be replaced with the
unit's MAC address in upper-case.
•
If "{MODEL}" is included in this URL, it will be replaced with the
unit's model name.
•
If "{fwver}" is included in this URL, it will be replaced with either
"FIRM_VER_EUDECT" or "FIRM_VER_USDECT" depending on
the system. Note that this rule differs from other parameters
such as "SIP_USER_AGENT".
4.3.4 Firmware Update Settings
Administrator Guide
151