Denon AVR-X3100W Owner's Manual page 225

Integrated network av receiver
Hide thumbs Also See for AVR-X3100W:
Table of Contents

Advertisement

Contents
Connections
Symptom
Dolby PLg mode or DTS
It cannot be selected when "Speaker Config." - "Center" or "Surround" is set for "None".
0
Neo:X mode cannot be
Dolby PLg or DTS Neo:X cannot be selected when using the headphones.
0
selected.
Audyssey MultEQ
®
XT,
These cannot be selected when you have not performed Audyssey
0
Audyssey Dynamic EQ
®
Switch to a sound mode other than "Direct" or "Pure Direct".
0
and Audyssey Dynamic
These cannot be selected when using the headphones.
0
Volume
®
cannot be
selected.
It can be selected when using the front height or front wide speakers.
Audyssey DSX
®
cannot be
0
selected.
It can be selected when using the center speaker.
0
Switch the sound mode to Dolby sound mode or DTS sound mode.
0
This cannot be selected when using the headphones.
0
This cannot be selected when an HD audio format with a sampling frequency of over 96 kHz is input
0
(such as may be found on select Dolby TrueHD and DTS-HD discs).
"Restorer" cannot be
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of
0
selected.
multichannel signals such as Dolby Digital or DTS surround, "Restorer" cannot be used.
Switch to a sound mode other than "Direct" or "Pure Direct".
0
No audio is output from
In ZONE2, the audio can be played back when signals input from digital connectors (OPTICAL/
0
PRE OUT or speakers for
COAXIAL) are in 2ch PCM format.
ZONE2.
In ZONE2, the audio can be played back when signals input from the HDMI connector are in 2ch PCM
0
format. To play back the audio in ZONE2 irrespective of the input signal format, set the "HDMI Audio"
setting in the menu to "PCM". Depending on the played back device, the audio may not be played back
even with this setting. In that case, set the audio format to "PCM (2ch)" on the played back device.
When listening to the audio of a Bluetooth device in ZONE2, remove any obstructions between the
0
Bluetooth device and this unit and use it within a range of about 32.8 ft/10 m.
Front panel
Display
Playback
Settings
Cause / Solution
Rear panel
225
Tips
®
Setup.
Remote
Index
Appendix
Page
191
180
121
192
191
120
157
121
207

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents