Brother FAX4750 Service Manual page 406

Difficulty
DOS Setup
I cannot print from my Check that the DOS application software
Printing
application software.
Difficulties
The machine prints,
but it prints incorrect
information.
Sometimes
it prints a couple of
characters and then
ejects the pages, etc.
The machine prints the This is common problem first with database
part of my document
but does not print the
last page (The LCD
shows REMAINED
DATA).
How can I change the
user settings or
default settings on the
machine?
The machine does not
Paper
load paper. The LCD
Handling
shows CHECK PAPER If so, the multi-purpose paper cassette may be
Difficulties
or PRINTER JAM.
The machine does not
feed paper from the
manual feed slot.
How can I load
envelopes?
T R O U B L E S H O O T I N G A N D R O U T I N E M A I N T E N A N C E
Suggestions
interface settings match those of your printer:
for example, if you are using a parallel printer
cable, you would probably set your DOS
software printer port to LPT1. Check for an
error message on the LCD.
This is an indication that your application
printer emulation Prints setting and the
machine's printer emulation do not match.
Check your application software to make sure
you selected the correct printer driver. The
machine emulates HP LaserJet IIP. Try setting
the machine to HP emulation in Remote
Printer Console and then select the
HP LaserJet IIP printer in your application
software.
software and part of spreadsheet software when
they are not correctly set up. The data has been
sent to the printer but the printer did not receive
the Page Eject command. Press
the page. Then ask your software supplier how
to add a Page Eject (or Form Feed) command to
the end of your print job.
Use the Remote Printer Console (RPC)
program.
Check to see if the CHECK PAPER or
PRINTER JAM message appears on the LCD.
out of paper or not properly installed. If it is
empty, load a new stack of paper into the
feeder. If there is paper in the multi-purpose
paper cassette, make sure it is straight. If the
paper is curled, you should straighten it.
Sometimes it is helpful to remove the paper,
turn the stack over and put it back into the
multi-purpose paper cassette. Reduce the
amount of paper in the multi-purpose paper
cassette, then try again. Check the manual feed
mode is not selected in the printer driver.
Reinsert the paper firmly, load one sheet at a
time. Make sure that manual feed mode is
selected in the printer driver.
You can load envelopes from the manual feed
slot. Your application software must be set up
to print the envelope size you are using. This is
usually done in the Page Setup or Document
Setup menu of your software. Refer to your
software application manual.
FF/Cont to eject
17 - 11