Table of Contents
Advertisement
SAT CONTROL SET
22
EN
Satellite Receiver Control Setting
Your unit
Satellite receiver
21-pin SCART cable
(supplied)
To [L-2 IN/
DECODER]
Back of unit
ENTER
Satellite receiver
Satellite Controller
(supplied)
(suggested location)
Transmitter
Satellite Controller
(supplied)
To [SAT CONTROL]
CABLE/SAT
TV
DVD
Selection Keys
FGDE
SET UP
The following procedure is required if you receive satellite
channels through a satellite receiver. Approximately 20 seconds
a
before the
timer programming (A pg. 45) or Manual
Timer programming (A pg. 47) starts, the unit sets its input mode
to AL-2B and automatically switches the satellite receiver's
channels using the provided Satellite Controller.
Installing Satellite Controller
1
Place the Satellite Controller so that the path between its
transmitter and the satellite receiver's remote sensor is
unobstructed.
2
Fix securely using the adhesive strip attached on the back of
the Satellite Controller.
3
Be sure to connect the unit's [L-2 IN/DECODER] connector to
the satellite receiver's 21-pin SCART connector.
NOTE:
When connecting your satellite receiver, refer to its instruction
manual.
4
Connect the Satellite Controller to the [SAT CONTROL]
connector on the rear panel.
Setting Satellite Receiver's Brand And Channel
After installation, set the satellite receiver's brand and channel
correctly; otherwise, the Satellite Controller cannot work correctly.
●
Turn on the unit.
●
Turn on the TV and select the AV mode.
●
Slide the TV/CABLE/SAT/DVD switch to DVD.
1
Turn on the satellite receiver's power.
2
Press SET UP to access the Main Menu screen.
3
Press selection keys to select AINITIAL SET UPB, then press
G.
4
Press selection keys
to select ATUNER
SETB, then press G.
5
Press selection keys
to select ASAT
CONTROL SETB, then
press ENTER.
6
Press selection keys
to select ABRANDB,
then press ENTER.
7
Press selection keys to select the brand code from the list on
page 23, then press ENTER.
●
If the unit is in playback or recording mode, you cannot set the
brand code.
8
Press selection keys to select APROGRAMMEB, then press
ENTER.
9
Press selection keys to select one of the channel positions on
the satellite receiver, then press ENTER.
●
You can select the channel position between 1 to 999.
10
Press selection keys
to select ATESTB, then
press ENTER. The
unit enters the Test
mode.
DVD VIDEO SET UP
HDD/DVD SET UP
FUNCTION SET UP
TUNER SET
CLOCK SET
AUTO CH SET
MANUAL CH SET
SAT CONTROL SET
GUIDE PROG SET
11
12
13
SELECT WITH @ THEN PRESS [ENTER]
SET UP
ENTER
PRESS [SET UP] TO EXIT
EXIT
SELECT
INITIAL SET UP > SAT CONTROL SET
73
BRAND
12
PROGRAMME
TEST
ENTER
SELECT WITH @ THEN PRESS [ENTER]
SET UP
PRESS [SET UP] TO EXIT
EXIT
SELECT
INITIAL SET UP
Advertisement
Table of Contents
