Taillamps, Turn Signal; Stoplamps, And Back-Up; Lamps (Ltz) - Chevrolet Malibu 2015 Owner's Manual

10-30 Vehicle Care
3. Remove the bulb socket by
turning counterclockwise and
pulling straight out.
4. Remove the bulb from the
socket.
5. Install the new bulb in the bulb
socket.
6. Install the bulb socket by turning
clockwise.
7. Install the trunk deck trim.
1. Stoplamp/Taillamp
2. Turn Signal Lamp
Caution
Improper lamp assembly removal
and installation can cause leaks
and water intrusion which may
cause damage to the taillamp. Do
not remove the taillamp assembly
to replace a bulb. Use the trunk
opening to access the bulb.
To replace any one of these bulbs:
Stoplamp/Taillamp and Turn
Signal Lamp
1. Open the trunk. See Trunk on
page 2-14.
2. Remove the push pins and pull
the trunk trim away from the
taillamp assembly.
3. Remove the bulb socket from
the taillamp assembly by turning
it counterclockwise.
4. Remove the bulb from the
socket by turning the bulb
counterclockwise one-quarter
turn and pulling it straight out.
5. Install a new bulb into the
socket.
6. Install the bulb socket into the
taillamp assembly by turning it
clockwise.
7. Install the trunk trim and
push pins.

Taillamps, Turn Signal,

Stoplamps, and Back-Up

Lamps (LTZ)

The trunk deck inboard taillamp is
an LED. To replace the taillamp see
your dealer.
Back-Up Lamp
1. Open the trunk. See Trunk on
page 2-14.
2. Remove the push pins and pull
back the trunk deck trim.