MTD 190-032 Operator's Manual page 8

IMPORTANT: It will be helpful to have a second person assist you
or a hydraulic floor lift to complete steps 3 through 6.
3. Place the undercarriage assembly beneath the tractor and
lift it up against the frame of the tractor. See Fig. 3-7.
4. The weld pins on the top of the undercarriage assembly
should go through the aligning holes found along the
tractor's frame. See Fig. 3-8.
5. Fasten the undercarriage assembly to the frame with the
four hairpin clips removed in step 2. See Fig. 3-8.
NOTE: There are two holes located on the left rear of the
mounting carriage. For 700 series tractors, use whichever
one is the easiest.
6. Route the upper drive belt around the engine pulley.
See Fig. 3-8.
NOTE: If you have an Electric PTO, proceed to Attaching the
Chute Directional Control.
8 s 3— a
ectiOn sseMbly
Figure 3-7
Figure 3-8
& s -u
et p
7. Attach the extension spring to the idler pulley. See Fig. 3-9.
Figure 3-9
8. Connect the other end to the tractor's frame rail. See Fig.
3-10.
Figure 3-10