Page 1
OPER/ TDR'S MANUAL 45" Snow Thrower Attachment Model 190-624 IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest- covered, brush-covered or grass-covered land unless the engine's exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any).
IMPORTANTs . THIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IF NOT FOLLOWED, COULD FOLLOW INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE YOUR SNOW ENDANGER PERSONAL SAFETY AND/OR PROPERTY OF YOURSELF AND OTHERS. READ AND THROWER ATTACHMENT. FAILURE= TO COMPLY WITH THESE...
Page 3
SECTION 1" LOOSE PARTS IN CRATE pack from crate. Be certain to remove all contents before Remove snow thrower, all loose parts and hardware discarding crate. • Discharge chute / tilt handle assembly •Snow thrower assembly • Front frame assembly •...
Page 4
SECTION 3: ASSEMBLY INSTRUCTIONS ATTACHING FRONT FRAME ASSEMBLY AND AUGER HOUSING (Hardware A) Auger NOTE: An adjustable lift link assembly is provided ousmg with the snow thrower attachment, ff there is not an Mounting Bracket adjustable lift link on your unit, remove the lift link on the left hand side of the unit, and replace it with the adjustable lift link provided.
Page 5
Secure the front tubing assemblies to the rear tubing with four (4) hex bolts 1/2-14 x 4" long, lock washers and hex nuts. Bolts go from inside out and the nuts and washers must go on the outside. See Figure 4. Hex Bolt (F) Wrenches 3/4"...