MTD 190-032 Operator's Manual page 7

Manual PTO Undercarriage Assembly Setup
1. Position the undercarriage on the floor beneath your
tractor close to the PTO cable. The small idler pulley should
be pointed towards the front of your tractor.
2. Attach the PTO cable to the idler bracket, then fit the cable
into the slotted fitting as seen in Fig. 3-3.
PTO Cable
Slotted Fitting
Figure 3-3
3. Refer to Fig. 3-4 for correct position.
Figure 3-4
Mounting The Undercarriage Assembly
NOTE: There are two different styles of undercarriages, yours
may differ slightly from the following images.
1.
Idler Pulley &
Idler Bracket
Forward
2.
If you have a 700 series tractor, remove the pin and wing
nut or hex nut at the right rear of the undercarriage
assembly before installing the undercarriage onto your
tractor. See Figure 3-5.
Figure 3-5
NOTE: To determine if you have a 700 series tractor, locate
the model plate found underneath the seat. If the fifth digit
from the left is a 7, then you have a 700 series tractor.
Remove and retain the four hairpin clips from the weld
pins found on the top side of the undercarriage assembly.
Remove and retain the two clevis pins with hairpin clips.
This hardware is for later installation. See Fig. 3-6.
Figure 3-6
s
ectiOn
3 — a & s -u
sseMbly et p
7