Subscribe to Our Youtube Channel
Related Manuals for Arada BK605
Summary of Contents for Arada BK605
- Page 1 Cassette Stove Installation Guide Width BK605 November 2013 EN 13240:2001+ Rev01 Amd. A2:2004...
-
Page 2: Table Of Contents
Should you have any questions about our stoves that are not covered in this manual, please contact the Arada retailer in your area, or call our technical support department on 08448 567181. You should retain these instructions for future reference. -
Page 3: Warnings
There must not be an extractor fan fitted in the same room as the stove as this can cause the stove to emit fumes into the room. Any manufacturer’s instructions must not be taken as overriding statutory requirements. Arada Ltd will not be responsible for any consequential or incidental loss or injury however caused. Health and Safety Before any installation work is undertaken consideration must be given to the Health and Safety at Work Act 1974. -
Page 4: Installation Requirements
Make sure that there is a gap between an un-insulated flue system and any combustible material. This gap must be at least 3X the outside diameter of the flue pipe, or 1.5X the flue diameter to non combustible surfaces. Arada Installation Manual... -
Page 5: Air For Combustion
If you plan to use an external air supply on a suitable stove, and have bought the appropriate Arada External Air Supply Kit, please refer to the instructions included with the kit on how to install it. The accompanying stove technical product sheet states whether or not your appliance is compatible with a Direct Air Supply Kit. -
Page 6: Installation Guide
(at which point a horizontal run is allowed up to 450mm in length): The appliance must either be DEFRA exempt or designated by Arada to only burn authorised smokeless fuel. (The user must also accept that they can only use smokeless fuel). ... -
Page 7: Installing The Stove
Once the throat plate has been removed you can also remove the rear liner(s). To replace the liners/throat plate follow the steps above in reverse. Arada Installation Manual... -
Page 8: Assembling Or Removing The Grate Bars
This should be achieved using fire cement. Any void surrounding an inset stove when installed should be filled with fire cement in the interest of safety and efficiency. Fitting the frame Please refer to the instructions included with the frame for information on how to fit them. Arada Installation Manual... -
Page 9: Commissioning The Stove
How to operate the riddling mechanism and air control lever. The importance of an adequate air supply to the room. The importance of regularly having the chimney swept / inspected. That a protective glove should be used when operating the stove. Arada Installation Manual... - Page 12 Telephone: +44 (0)1297 35700 Technical Helpline: +44 (0)8448 475107 Please Note: Arada has a policy of continuous product development and therefore we reserve the right to amend specifications without prior notice. Due to printing cycles, items, options or information may be offered prematurely or now be obsolete, please check with your retailer or dealer.
Need help?
Do you have a question about the BK605 and is the answer not in the manual?
Questions and answers