Precautions For Installation - Panasonic WV-CF504 Installation Manual

Precautions for installation

The following points as well as the contents of "Warning" and " Caution" shall be
observed.
Panasonic assumes no responsibility for injuries or property damage resulting from fail-
ures arising out of improper installation or operation inconsistent with this documenta-
tion.
Installation work shall be performed in accordance with the technology standard of the
electric installation.
This product is designed to be used
indoors.
This product is not operable outdoors.
Do not expose the product to direct sunlight for
hours and do not install the product near a
heater or an air conditioner. Otherwise, it may
cause deformation, discoloration and malfunc-
tion. Keep the product away from water and
moisture.
Installing place
Contact your dealer for assistance if you are
unsure of an appropriate place in your particu-
lar environment.
• Make sure that the installation area is
strong enough to hold the product, such
as a concrete ceiling.
• Install the camera in the foundation area of
the architecture or where sufficient strength
is assured.
• If a ceiling board such as plaster board is
too weak to support the total weight, the
area shall be sufficiently reinforced.
Avoid installing this product in the follow-
ing locations.
• Location where it may get wet from rain or
water splash.
• Locations where a chemical agent is used
such as a swimming pool.
• Locations subject to steam and oil smoke
such as a kitchen, Locations near flamma-
ble gas or vapor.
• Locations where radiation or x-ray emis-
sions are produced.
• Locations where corrosive gas is pro-
duced, Locations where it may be dam-
aged by briny air such as seashores.
• Locations where the temperature is not
within –10 °C to +50 °C {14 °F to +122 °F}.
• Locations subject to vibrations (This prod-
uct is not designed for on-vehicle use.)
Avoid moist or dusty places to install this
system.
Otherwise, lifetime of the internal parts may be
shortened.
Avoid installing the camera in a place with
a high level of noise.
Installation near an air conditioner, an air clean-
er, a vending machine, or the like causes noise.
Be sure to remove this product if it is not
in use.
Keep the camera cable away from the
lighting cable.
Failure to observe this may cause noise.
Radio interference
When the camera is used near TV/radio anten-
na, strong electric field or magnetic field (near a
motor or a transformer), images may be dis-
torted and noise sound may be produced.
In such a case, run the camera cable through
specialized steel conduit tubes.
Locally procure the screws
Screws are not supplied with this product. Pre-
pare the screws according to the material,
structure, strength and other factors of the
11