Stoves Hobs, Grills And Ovens - Swift Rio Owner's Handbook Manual

Equipment Details
AFTER USE, ALWAYS SHUT OFF THE
GAS SUPPLY FROM THE CYLINDER
ATTENTION! When replacing the gas cylinder,
the following precautions must be taken:
a. Close tapes to the appliance (pos.
b. Make sure there are no flames or fires lit
in the proximity;
c. Close valve of cylinder to be replaced;
d. Unscrew regulator from empty cylinder
and remove from its storage
compartment. Reverse procedure for
replacement. Check possible gas leaks
by means of a soapy solution as
described above.
e. Ignite burners and check correct
operation. Contact an authorised
technician if the unit shows signs of
failure.
GAS LEAKS
We recommend using an approved electronic
detector for gas leaks.
If you smell gas:
a. Open window and immediately get all
people out of the motorhome.
b. Do not touch electrical switches, light
matches or do anything that could ignite
gas.
80
c. Extinguish any open flame.
d. Close cylinder or tank supply valves. Do
not turn on valves until leak has been
corrected.
e. Immediately call an authorised
serviceman.
);
CLEANING AND MAINTENANCE
Turn off the appliance and allow to cool
before cleaning. Cold water or a damp cloth
may damage hot surfaces.
Do not use abrasive, corrosive, chloride-
based products or steel pads. Do not leave
acidic or alkaline substances e.g. vinegar,
salt, lemon juice etc, on the appliance
surfaces.
Stainless steel surfaces and enamelled parts
should only be washed with soapy water or
neutral detergent, rinsed and dried. Only use
clean sponges or cloths.
STOVES HOBS, GRILLS AND
OVENS
BURNER IGNITION
The hotplate lid must be open for the
hotplate, grill or oven burners to ignite.
The ignition should not be operated for more
than 15 seconds. If, after 15 seconds the
burner has not lit, stop operating the ignition,
open the compartment door and wait at least
1 minute before attempting to ignite the
burner.
In the event of the burner flames being
accidentally extinguished, turn off the burner
control and do not attempt to re-light the
burner for at least 1 minute.
SPARE PARTS
When ordering spare parts, please give the
following information so the appliance can be
correctly identified:
1. The name of the appliance from the facia,
and its colour.
2. The model number and the serial number
of the appliance (from the data badge).
BE SAFE - NOT SORRY
Warning: Good ventilation is essential to the
continuing safe operation of all gas
appliances. Do not allow any ventilation
openings to become accidentally or
deliberately blocked.