Ness Security Products SecurityGuardII Owner's Manual page 5

Siren
Power Outlet
Battery Charger
SIREN The extremely loud siren sounds if
an intruder is detected or a Radio
Key emergency button is pressed.
It is also used to give you various
"Beep" warnings.
STATUS DISPLAY A very bright, red, dual 7 segment
display which is used to display
the status of SecurityGuard and
provide various warnings for
conditions such as Low batteries
etc.
DETECTOR
Infra-Red detector used to detect
movement from intruders in an area
of up to 12 metres x 12 metres.
S E C U R I T Y G U A R D I I
O.K. Light
Status Display
Detector
Charging Plug
An inbuilt
5
O.K. / BATTERY Flashes briefly every 5 seconds if the
battery is charged and SecurityGuard
CHARGE LIGHT
is functioning correctly. Flashes every
2 seconds in Home Mode.
On constantly and blink off every 5
seconds while battery is charging.
BATTERY CHARGER Used to charge SecurityGuard's
battery. This low voltage device does
not
have any dangerous voltages at it's
plug connected to SecurityGuard. DO
NOT use the charger on any other
appliance as damage to the appliance
or charger may occur.
BATTERY The internal rechargeable battery
will run SecurityGuard for around
3 to 4 months under normal operating
conditions, before it requires recharging.
EMERGENCY OVERRIDE KEY SWITCH
In case you lose your Radio Key or you cannot stop the Siren
on your SecurityGuard with your Radio Key then the Override
Keyswitch on the bottom of the SecurityGuard can be used to
totally disable SecurityGuard. Two keys are supplied and
should be kept in a safe place. Note that the Keyswitch cannot
be used to Arm and Disarm SecurityGuard. It completely
disables SecurityGuard when it is turned off.
The illustration above shows the keyswitch in the OFF position
(SecurityGuard Disabled).
If you have turned the Keyswitch off and back on again wait
at least 5 minutes after turning on before you ARM
SecurityGuard,
to allow the inbuilt PIR to settle otherwise false
alarms may occur.
WARNING: Do not press any Radio Key buttons until the
display has stopped flashing. If you turned your Keyswitch off
because you had a problem and the problem still exists after
you have turned back on, then contact the service number you