Ness Security Products SecurityGuardII Owner's Manual page 14

B A T T E R Y C H A R G I N G
SecurityGuards battery should only need charging every 3 to 4
months under normal usage. SecurityGuard will warn you when
it's battery needs charging by sounding a series of double
beeps for 3 seconds when you Disarm after the normal
3 beeps SecurityGuard will also flash
5 minutes.
(As with all SecurityGuard displays you may choose to stop the
display before the 5 minutes by pressing
When SecurityGuard has a low battery it will continue to
function normally for up to a week, however you should charge
SecurityGuard as soon as possible.
Plug your Charger into the bottom of your SecurityGuard and
into the nearest power point.
WHEN YOU PLUG IN THE CHARGER
• The O.K. / Battery Charge light will illuminate constantly and
blink off every 5 seconds.
• The Lo display will extinguish, to indicate that the battery
is charging.
• When the battery is fully charged the O.K. light will revert
back to it's normal blink on every 5 seconds and the charger
may be disconnected.
• The battery will take approximately 24 hours to fully charge.
B A T T E R Y C H A R G I N G
on it's display for
on any Radio Key).
Display is clear
Although SecurityGuard may only need charging every 3 to 4
months you may intend to be away for extended periods of time
and you may not be sure when you last charged SecurityGuard.
SecurityGuard has been designed to safely leave the charger
connected permanently so you may wish to leave the charger
plugged in for the time you are away or if it is more convenient
you may wish to leave it permanently connected.
There are no dangerous voltages present at
your charger and it is quite safe to handle,
however please keep it away from excessive moisture
as damage may occur to the charger.
Keep the charger plug clean and always inspect it before
plugging into SecurityGuard to ensure that no dust or other
material has collected inside.
14
N O T E