Table of Contents
Advertisement
A R M I N G
To Arm your SecurityGuard press the
Radio Key.
Your SecurityGuard will Beep once
Your SecurityGuard will be programmed with a short Exit Time,
this allows you to depart your premises without triggering an
alarm. Your SecurityGuard will Beep once
Exit Time has finished and it is now ready to detect intruders.
D I S A R M I N G
To Disarm your SecurityGuard press the
any Radio Key.
Your SecurityGuard will Beep three times
be displayed.
When Disarmed the O.K. light will flash once every 5 seconds
to indicate that SecurityGuard is happy and all is O.K. If the
Battery Charger is plugged in the O.K. light will be on constantly
and blink off once every 5 seconds.
O P E R A T I N G Y O U R A L A R M
button on any
and
will be displayed.
more to warn that
button on
and
will
O T H E R W A R N I N G S
When you Disarm your SecurityGuard it may have some
warnings to give you. SecurityGuard will alert you by sounding
a series of Beeps
of the normal 3 Beeps
accordingly.
The warnings may be for Low Battery or Alarms, these are fully
explained later in this manual.
The Display will remain flashing for 5 minutes after you Disarm,
you may choose to stop the display by pressing OFF once. You
can also recall warning displays at any time by simply pressing
OFF again, this will bring the flashing display back for another
5 minutes.
When SecurityGuard has more than one warning to give,
pressing the
button repeatedly will cycle you through the
displays.
Your outside siren may beep when you Arm and
Disarm if programmed.
If a Strobe light is fitted to your outside siren,
it will flash briefly when you Arm and Disarm
11
or double beeps
and a message will be displayed
O P T I O N A L
instead
Clear
Advertisement
Table of Contents
