Maintenance - Ness Security Products SecurityGuardII Owner's Manual

Ness security products securityguardii intruder alarm system
Table of Contents

Advertisement

T E S T I N G
We strongly suggest that you should carry out a full test of your
alarm system at a minimum 6 monthly interval.
You should Arm your SecurityGuard and test that each of your
PIR and Reed Switch detectors triggers an alarm as
programmed. A test procedure is described for each detector
in the replacing batteries section of this manual.
You could also check that your sirens are fully functional by
triggering an Emergency alarm from your Radio Key.
C L E A N I N G
Do not clean SecurityGuard with solvents like benzine or
thinners and do not use commercial spray pack cleaners as the
chemicals may attack the polycarbonate housing of
SecurityGuard.
A light dusting and if necessary warm
soapy water should only be used for
cleaning.
The same applies for your Radio Key,
PIR and Reed Switch housings.
I N S E C T S
Take particular care that insects like spiders and moths are
not forming webs or similar around any of the PIR detectors
including SecurityGuards inbuilt
detector. Insects can cause false
alarms. Brush away any spider webs
and if insects appear to be a problem
spray around the detector with a
surface insect spray.
Do Not Spray Directly Onto The
Detector or Lens Area !
M A I N T E N A N C E
B A T T E R I E S
Your PIR, Reed Switch and Radio Key batteries should last
approximately 2 years under normal usage when you use the
recommended Lithium batteries. We would advise that you
replace the batteries at this interval even if you have not
received a Low Battery warning.
S P E C I F I C A T I O N S
SecurityGuard
Model No
Weight
Dimensions
Radio Frequency
Radio Frequency
Siren
Display
Battery
Battery Charger
Voltage in
Voltage in
Voltage out
Radio Key
Frequency
Frequency
Battery
Transmit Power
Transmit Power
P.I.R.
Frequency
Frequency
Battery
Transmit Power
Transmit Power
Reed Switch
Frequency
Frequency
Battery
Transmit Power
Transmit Power
Manufactured in Australia by Ness Security Products Pty Ltd.
NOTE: Specifications subject to change without notice in the
course of further development.
21
SG
II
2.4 KG
800 x 115 x 80 mm
303.875 Mhz. Aus, USA, Canada
418 Mhz. UK 433 Mhz. Europe
> 120 db @ 1 metre
Dual 7 Segments
12 V Sealed Lead Acid 2.8 - 3.2 AH
220v - 260v A.C. Aus, UK
110v - 130v A.C. USA, Canada
17 V A.C. @ 300 mA
303.875 Mhz. Aus, USA, Canada
418 Mhz. UK 433 Mhz. Europe
3V Lithium Coin Cell
12 V Alkaline (International Key)
10 uW PEP MAX. Aus, USA, Canada
100 mW PEP MAX. UK
303.875 Mhz. Aus, USA, Canada
418 Mhz. UK 433 Mhz. Europe
9 V Lithium
10 uW PEP MAX. Aus, USA, Canada
100 mW PEP MAX. UK
303.875 Mhz. Aus, USA, Canada
418 Mhz. UK 433 Mhz. Europe
3V Lithium Coin Cell ( Mini Reed )
9V Lithium (Shock Reed)
10 uW PEP MAX. Aus, USA, Canada
100 mW PEP MAX. UK

Advertisement

Table of Contents
loading

Related Products for Ness Security Products SecurityGuardII

This manual is also suitable for:

Security guard

Table of Contents