Table of Contents
Advertisement
O P E R A T I N G Y O U R A L A R M
O P T I O N A L H O M E M O D E
Your SecurityGuard alarm system may be programmed to
operate a Homemode. Home mode allows some Detection
devices (PIRs and Reed Switches) to cause an alarm while
other detection devices are ignored. This is normally used
while you are at home and want certain areas of your home
secure while you are there.
To place SecurityGuard in Home mode
Press the
button on any Radio Key twice within 3 seconds.
Your SecurityGuard will beep 5 times
displayed thereafter, the O.K. light will flash once every 2
seconds to indicate SecurityGuard is in Home mode.
If the battery charger is plugged in and the O.K. light is
illuminated constantly it will blink off every 2 seconds to
indicate SecurityGuard is in Home Mode.
Note - Exit Time applies to Home mode as per normal Arming,
therefore one extra beep
NOTE
The detection devices required to be in
Home Mode will be set by your technician
at the time of installation
Refer to the table on the back page
for home detectors.
and
will be
will sound at the end of Exit time.
A L A R M S
Your SecurityGuard will be programmed to sound one of two
types of Alarm in Home mode, when a home detector is
triggered;
Full Alarm
Where the normal Alarm siren will sound
for up to 5 minutes.
Home Chime
Where your SecurityGuard will sound a
low volume two-tone siren for 5 seconds
whenever a Home detection device is
triggered.
D I S A R M I N G
To turn SecurityGuard Off or to stop any alarms that have
happened in Home mode Press
SecurityGuard will beep 3 times
13
or
on any Radio Key once.
and
will be displayed.
Advertisement
Table of Contents
