How To Install On An Inclined Place - Daewoo DWF-650 Service Manual

5. DIRECTIONS FOR INSTALLATION AND USE
Installing Place
Install the washer on a horizon-
tal solid floor. If the washer is
installed on an unsuitable floor,
it could make considerable
noise and vibration.
è
§ §
Installation Of The Under Base Cover [Option]
-DWF-5510/5511/5010/6011
1 Before installing your
washer, remove the
pad from the bottom
of the cabinet. Then,
separate under cover
from rear side of cab-
inet by unscrewing
and insert it into the
base.
-DWF-5520/5521/6020/6021
1 There is under-base
cover in the tub of the
washer. Put out and
draw it in its proper
site. (See picture)
è
§ §

How To Install On An Inclined Place

1
Horizon
Setting
After controlling the height
by turning the adjustable
leg, let the washer put
down to the ground.
8 DIRECTIONS
Keep the machine body more
than 25cm apart from the wall
surface. It will make easy clean-
ing the drain filter which is
equipped at the back side of it.
And if it comes into contract
vibration may occur.
10Cm
SCREW
2 Check the Horizon
Status
Check the position of tub above
the center of the washer.
Never install in these places
¡ The place where it would be
exposed to direct sunlight.
¡ The place nearby a heater or heat
appliance.
¡ The place where it would be sup-
posed to be frozen in winter.
¡ The kitchen with coal gas and a
damp place like a bathroom.
2 Push the under-base
cover into the end, which
decrease the noise made
by this washer.
2 Push the under-base
cover into the end, which
decrease the noise made
by this washer.
NOTES
The openings must not
be obstructed by carpet-
ing when the washing
machine is installed on a
carpeted floor.