Table of Contents
Advertisement
Troubleshooting
What appears to be a malfunction may not always be serious. Please go through the following list before
requesting service.
Symptom
Power does not come on.
Remote control does not work.
The TV/VIDEO - CANCEL,
CURSOR or numeric buttons do
not work.
No picture is displayed on the
monitor.
Picture is not normal when
using the S-VIDEO jack.
Picture is noisy.
No audio is reproduced.
No audio is reproduced when
playing back a DVD disc
recorded with 96 kHz, linear
PCM audio.
Sound is distorted or noise is
generated.
Picture does not fit the
television screen.
Operation is not possible.
Possible case
Power plug is not inserted securely.
Too far from the unit.
The tip of the remote unit is not
pointed in the right direction.
Batteries are exhausted.
Battery polarity is incorrect.
The TV - DVD switch is not correctly
set.
Connection of video cable is incorrect.
Input selection of TV is incorrect.
Disc is not playable.
The unit is set to feed the RGB
signals (instead of the S-video
signals).
The unit is connected to a VCR
directly and the copyguard function
is activated.
Connection is incorrect.
Input selection of amplifier is
incorrect.
The audio signal is not derived
from the unit's DIGITAL OUT.
Disc is dirty.
MONITOR TYPE is not correctly set.
Television is not correctly set.
Microcomputer malfunction due to
lightning or static electricity.
Moisture condensation caused by a
sudden change of temperature or
humidity.
Additional information
Remedy
Plug in securely.
More closer to the unit.
Point the infrared light- emitting
window toward the remote sensor on
the front panel.
Replace the batteries with new ones.
Take out the batteries and insert them
again in the correct direction.
To control the unit, set the TV - DVD
switch to "DVD." To control your TV,
set the TV - DVD switch to "TV."
Connect the cable correctly.
Select correctly.
Use a playable disc (see page 12).
Make the unit feed the S-video signals
(see pages 13 and 15).
Connect the unit so that the picture
signal flows directly to the TV.
Check the connections.
Select correctly.
Use the AUDIO OUT when playing back
such discs.
Wipe the disc surface.
Select monitor type correctly (see page 48).
Set the television correctly.
Turn off the power and unplug the
power cord, then connect the power
cord again.
Turn off the power, then turn it on a few
hours later.
English
53
Advertisement
Table of Contents
