JVC DR-M100S Instructions Manual page 40

TIMER RECORDING
40
EN
To Timer Record The Program With The Programmed
Disc
1
Load a programmed disc.
2
Press DVD A to turn off the power.
●
appears on the front display panel, and the unit enters
into timer standby mode.
● To disengage the timer mode, press DVD A again.
NOTES:
●
On-Disc Timer Programming is not possible on a DVD-R or
DVD-RW (Video mode) disc.
●
The information of a program recorded with On-Disc Timer
Programming is not stored in the library.
●
The play list is not created for the programs recorded with On-
Disc Timer Programming.
●
Programs recorded with On-Disc Timer Programming cannot be
edited or protected.
●
On-Disc Timer Programmed discs cannot be used for other
recordings other than On-Disc Timer Programming.
●
On-Disc Timer Programmed discs cannot be used on units from
other manufacturers.
●
The beginning of a program may not be recorded. In addition, if
the 1st program's recording stop time and the 2nd program's
recording start time is the same, the ending of the 1st program
may not be recorded.
●
If there is a power outage while recording, the recordings when
the power outage occurs are not guaranteed.
How Discs Are Overwritten
(Example 1)
To record a 1 hour serial drama every Friday in SP mode
1st
Blank
2nd 3rd
The first program is
overwritten by the third.
(Example 2)
To record a 15 minutes serial drama every morning in XP
mode
4th 1st
12/6 12/3
3rd 2nd
12/5 12/4
(Example 3)
To record a 90 minutes serial drama every Sunday in SP
mode
Blank
1st
3rd
Blank
NOTE:
On-Disc Timer Programming may not always work as these
examples.
2nd 1st
4th 3rd
The second program is
overwritten by the
fourth.
8th 5th
12/10 12/7
7th 6th
12/9 12/8
2nd
Blank
Areas treated as blank
cannot be played back
even if they contain
recorded material.