Common Operations; Turning On Or Off The Power; Setting The Clock; Setting The Am Tuner Interval Spacing - JVC CA-MXDVA9 Instructions Manual

Common Operations

Turning On or Off the Power

To turn on the unit, press
STANDBY/ON so that the
STANDBY lamp goes off.
To turn off the unit (on standby), press
STANDBY/ON again so that the
STANDBY lamp lights up.
• A little power is always consumed even while the unit is on
standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to "0:00" right away, while the tuner preset
stations (see page 15) will be erased in a few days.

Setting the Clock

Before operating the unit any further, first set the clock built
in this unit. You can set the clock whether the unit is on or
off.
On the unit ONLY:
1
Press CLOCK/TIMER.
The hour digits start flashing on the display.
2
Turn 4 / ¢ to adjust the
hour, then press SET.
The minute digits start flashing on
the display.
• If you want to correct the hour after
pressing SET, press
CANCEL/DEMO.
The hour digits start flashing again.
3
Turn 4 / ¢ to adjust the minute, then
press SET.
To check the clock time
Press and hold SET while playing any source.
• Pressing SET, the source indication appears again.
STANDBY/ON
STANDBY
To adjust the clock again
If you have adjusted the clock before, you need to press
CLOCK/TIMER repeatedly until the clock setting mode is
selected.
STANDBY/ON • Each time you press the button, the clock/timer setting
modes change as follows:
STANDBY
The clock is reset to "0:00" right away. If this happens, set the clock
again.

Setting the AM Tuner Interval Spacing

Some countries space AM stations 9 kHz apart, and some
countries use 10 kHz spacing.
On the unit ONLY:
When shipped, the unit is set to 9 kHz spacing.
You can only change the AM tuner interval spacing while
tuning into an AM station. (See page 15.)
Press STANDBY/ON
down 7.
• Each time you press these buttons, the
AM tuner interval spacing alternates
between 9 kHz and 10 kHz.
– 11 –
DAILY ON TIME
(Daily timer setting)
Clock
Canceled
setting
(The hour digits
start flashing.)
When you unplug the AC power cord or if a power
failure occurs
while holding
REC
ON TIME
(Recording
timer setting)
+
STANDBY/ON
STANDBY