Advertisement
1. Ice Maker
5. Leveling Bracket
(mounted on Ice maker)
ICE MAKER INSTALLATION INSTRUCTIONS
1. Unplug refrigerator from electrical outlet.
2. Remove ice tray rack from freezer (some models).
3. Remove spacer. Remove freezer shelf (some models) by pushing shelf to left until right side of shelf
comes free from holes. Then slowly lift up and pull shelf free from holes on right side.
NOTE
There are two plugs on the left freezer wall that must be removed. These holes will be used to mount the Ice
Maker (1).
4. Use a plastic putty knife to remove plugs and cover from inside freezer compartment. Use a ¼ inch socket
wrench or nut driver to remove harness connector cover. (See Figure 1.)
5. Start two, long, Ice Maker mounting screws (3) into freezer wall where plugs were removed in Step 4. Turn
each screw clockwise five turns. (See Figure 2.)
Harness Connector Cover
Screw
figure 1
USE ThIS PAgE TO IDENTIfy PARTS
2. Ice Container
•
Plastic Putty Knife
•
¼ inch Socket Wrench or Nut Driver
•
Adjustable Wrench
Plastic Plugs
3. Screws - Qty 2
Tools Required:
2
4. Leveling Bracket Screw
(used to mount leveling
bracket to Ice maker)
figure 2
(3) Ice Maker
Mounting Screws
Advertisement
