Introduction...............................................................................
Limited Warranty....................................................................
USA CANADA 1-800-
ICE MAKER
EFIC128-BLACK-6COM,
EFIC128-SILVER-6COM
2
3
5
7
8
9
10
11
Need help?
Do you have a question about the EFIC128-BLACK-6COM and is the answer not in the manual?
Questions and answers
The Add Water light comes on when there is plenty of water in the tank. I tried unplugging and restarting, turning on and off, and emptying and refilling the tank--still not working.
@Kathy Strang same issue here. Had to run a few cleaning cycles and now it's just moving back and forward. No pumping water.
The "Add Water" light may stay on despite having enough water due to a malfunction or misreading of the water level sensor. This can happen if the sensor is dirty, faulty, or not detecting the water properly. Try stopping the ice maker, refilling the water, and pressing the “ON/OFF” button again to restart the unit.
This answer is automatically generated
My unit is saying "add water" but I have plenty of water (above fill line) in it. Ive already attempted to add more water, power off/on and unplug multiple times without any improvement. I emptied that water and trying to wipe down the water intake area in case debris was clogging this area. Can you please help?
The "ADD WATER" message on the Frigidaire EFIC128-BLACK-6COM could appear even if there is enough water due to a malfunction in the infrared sensor, possibly caused by direct sunlight or its reflection. Moving the unit to a location without sunlight exposure may resolve the issue.
This answer is automatically generated
The light indicate ice is full not of to make ice
The "ICE FULL" light on the Frigidaire EFIC128-BLACK-6COM may not turn off due to one of the following reasons:
1. Ice is full in the basket – Remove ice from the basket.
2. Infrared sensor malfunction – Direct sunlight or reflections may interfere with the sensor. Move the unit to a location without sunlight exposure.
3. Sensor is obstructed or not working properly – If ice is blocking the sensor and the unit doesn’t stop, relocate the unit or check for sensor issues.
To reset, remove the ice and press the "Select" button for 5 seconds to allow the unit to make up to 10 more cycles.
This answer is automatically generated
How do I deep clean the FRIGIDAIRE EFIC128AMZBLK Compact Countertop Ice Make,
To deep clean the Frigidaire EFIC128-BLACK-6COM Compact Countertop Ice Maker, follow these steps:
1. Unplug the Unit: Disconnect the ice maker from the power supply to ensure safety.
2. Drain the Water: Remove the drain cap at the front bottom side to empty any remaining water from the reservoir.
3. Remove Ice Basket and Scoop: Take out the ice basket and scoop to access the interior.
4. Clean the Interior: Use a soft cloth or sponge with mild detergent and warm water to wipe the inside surfaces, including the reservoir. Rinse thoroughly with clean water.
5. Clean the Exterior: Wipe the outside of the unit with a damp cloth.
6. Dry the Unit: Let all parts dry completely before reassembling. Leave the top cover open to allow air drying.
7. Reassemble: Put the ice basket and scoop back inside. Reattach the drain cap.
8. Restart Safely: Wait at least 3 minutes after moving or cleaning before turning the unit back on, to allow refrigerant to settle.
Replace the water every 24 hours for hygiene, and clean the unit regularly if not used frequently.
This answer is automatically generated
I need to buy the ice basket for my Frigidaire EFIC128-AMZ-BLACK. Can you send me a website to purchase this part?
It’s full of water, but it says to add water