Troubleshooting - JVC AX-V55BK Instructions Manual

Troubleshooting

Page 27
Use this chart to help you solve daily operational problems. If there is any problem you cannot solve, contact
your JVC service center.
PROBLEM
The display does not light up
No sound from speakers
Sound from one speaker only
Howling during record
playing
Remote control does not
work
POSSIBLE CAUSE
The power cord is not plugged in
or the POWER switch is pressed
to set in the —OFF position
Speaker signal cables are not
connected
The SPEAKERS 1 and 2 are not
set correctly
An incorrect source is selected
Speaker signal cables are not
connected properly
The balance is set to one extreme
Your turntable is too close to
speakers
There is an obstruction in front of
the remote sensor on the
amplifier
Batteries are weak
SOLUTION
Plug the power cord into an AC outlet
and press POWER to set it in the _ON
position
Check speaker wiring and
reconnect if necessary
Press SPEAKERS 1 and 2 correctly
Select the correct source
Check speaker wiring and reconnect if
necessary
Adjust the balance properly (see page
12)
Move speakers away from the turntable
Remove the obstruction
Replace batteries