Using The Remote Control - JVC AX-V55BK Instructions Manual

Using the Remote Control

You can operate JVC audio and video components with the amplifier's remote control, since control signals for JVC components are preset in
the remote control.
To operate these components with the remote control, first select a source with the source buttons on the remote control. Then, operate that source
using the remote control.
IMPORTANT:
To operate JVC audio components using this remote control:
• You need to connect JVC audio components through the COMPU LINK-3 SYNCHRO jacks (see page 7) in addition to the
connections using cables with RCA pin plugs (see page 6).
• Aim the remote control directly at the remote sensor on the amplifier.
/I
TV
TV VCR AUDIO
/VIDEO
PRESET SEA MODE
+
CH 1 2 3
TEST DELAY
SURR MODE
–
CH 4 5 6
– +
REAR
CD 7/P 8 9
– +
CENTER
TAPE CD-DISC 10 +10
SEA SURROUND
AUDIO
TUNER
CONTROL ON/OFF ON/OFF
TV CONTROL
– +
VCR TV
VOLUME
ONE TOUCH
VIDEO
OPERATION
PTY SEARCH DISPLAY
– +
PTY SELECT
PHONO
– +
VOLUME MUTE
RM-SAV5RU REMOTE CONTROL
Page 25
After pressing TUNER, you can perform the following operations:
1 — 10, +10 Selects a preset channel number directly
For channel number 5, press 5.
For channel number 15, press +10, then 5.
For channel number 20, press +10, then 10.
For channel number 30, press +10, +10 then 10.
RDS operating buttons
PTY SEARCH Starts and ends searching a broadcast using the RDS.
PTY SELECT +/– Selects a program type.
DISPLAY Changes the RDS display mode.
After pressing CD, you can perform the following operations on a CD player:
3
Starts playing
4
Returns to the beginning of the current (or previous) track
¢
Skips to the beginning of the next track
7
Stops playing
8 Pauses. To resume playing, press 3.
1 — 10, +10 Selects a track number directly
For track number 5, press 5.
For track number 15, press +10, then 5.
For track number 20, press +10, then 10.
For track number 30, press +10, +10, then 10
After pressing CD-DISC, you can perform the following operations on a CD player-changer:
1 — 6, 7/P Select the number of a disc installed in a CD player-changer. Then continue to
operate the CD player as described above.
After pressing TAPE, you can perform the following operations on a cassette deck:
3
Starts playback
4
Fast winds a tape from right to left
¢
Fast winds a tape from left to right
7
Stops operation
8 Pauses. To resume playing, press 3.