Media Cutting Sequence - MUTOH Rockhopper 46 Maintenance Manual

Media Cutting Sequence

Detects trailing edge of media
(2)
< Printing in progress ? >
Media Cutting
No
< Manual cutting requested ? >
No
< XR sensor is "off" status ? >
Yes
< Is ink drying period finished ? >
< Manual cutting requested ? >
[Moves to a point 1/3 of media from right edge]
[Cut towards (1)]
[Moves to a point 1/3 of media from left edge]
[Cut towards (2)]
[Moves to a point 1/3 of media from left edge]
[Cut towards (3)]
[Try to shake out the media]
Retry once if media can not be shaken out
< There is media at the position detected by
Yes
the edge sensor >
[ End ]
Media Cutting Sequence
(3) (1)
Yes
If media has just been initialized, feed 10 mm
No
Yes
[Moves 20 mm forward] (45 mm in the case of a retry)
[Moves 20 mm back] (45 mm in the case of a retry)
No
< Tried 3 times ? >
Yes
[Moves 5 mm forward]
[Moves 5 mm back]
No
< Tried 3 times ? >
Yes
No
Maintenance Unit
[Wait ink drying period]
[Moves forward 186 mm]
Yes
< Manual cut finished key entry occurred >
[ End ] [Waiting for key entry]
Model Name: Rockhopper-46/62
[Media cutting error]
Model Name: Rockhopper-46/62
G I D 4 0 7 0
G I D 4 0 7 0