Lcd Monitor Indications During Playback; Warning Indications - JVC GR-DVM1DU Instructions Manual

Y
I
LCD Monitor Indications During
Playback
No. NAME & FUNCTION
t
Playback sound mode display (
y
"Tape Running" indicator:
Cassette mark
loaded or a tape reaches its end.
Audio Dubbing mode indicator: 6e
u
Insert Editing mode indicator (
i
Date/Time Display
o
Fast-Forward indication
p
Rewind indication
Q
Time Code Display
W
Play/Pause indication
"STILL" is displayed during playback.
E
Stop indication

Warning Indications

No. NAME & FUNCTION
R
"Battery Low" indicator
Changes as follows according to the
remaining power level:
When the battery power is coming to an
end, the battery indicator (
LCD monitor. After indication blinks, power
turns off automatically. Replace the battery
pack with a fully charged one.
t
32kHz / SOUND1
T AP E !
0 0 : 0 0 : 0 0
STOP STILL
E W
pg. 55)
appears when no tape is
( pg. 65)
pg. 66)
( pg. 55)
( pg. 49)
( pg. 49)
( pg. 55)
( pg. 49)
( pg. 49)
) blinks in the
U R
6e
SP
6w
25 ' 9 7
DEC
10 : 3 5
AM
REW FF
Q p o
No. NAME & FUNCTION
T
Head clog warning
At the start of recording, appears and blinks
if dirt is detected on heads. Stop recording
and clean the heads using the Cleaning
Cassette.
Y
Condensation warning
When this indicator appears, all functions
are disabled. Turn the unit off for a few
hours, and when you turn it on again the
indicator should disappear.
U
Clock Battery warning
Appears when the clock (lithium) battery is
not in place or exhausted. For inserting or
replacing the clock battery, refer to page 11.
I
"No Tape Loaded" indicator
Appears for 10 seconds after power is turned
on if there's no tape loaded.
— "Tape End" indicator
— An error number (E01, etc.)
appears
Consult your nearest JVC dealer.
— "ERROR: REFER MANUAL" indicator
Appears when Audio Dubbing or Insert
Editing is impossible.
75
y
u
i
( pg. 79)
( pg. 22)
( pg. 71)
( pg. 65, 66)