JVC GR-D850U Instructions Manual page 48

48
Cautions
EN
How To Handle A CD-ROM
• Take care not to soil or scratch the mirror
surface (opposite to the printed surface).
Do not write anything or put a sticker on either
the front or back surface. If the CD-ROM gets
dirty, gently wipe it with a soft cloth outward
from the center hole.
• Do not use conventional disc cleaners or
cleaning spray.
• Do not bend the CD-ROM or touch its mirror
surface.
• Do not store your CD-ROM in a dusty, hot or
humid environment. Keep it away from direct
sunlight.
About moisture condensation
• You have observed that pouring a cold
liquid into a glass will cause drops of
water to form on the glass' outer surface.
This same phenomenon occurs on the
head drum of a camcorder when it is
moved from a cool place to a warm
place, after heating a cold room, under
extremely humid conditions or in a place
directly subjected to the cool air from an
air conditioner.
• Moisture on the head drum can cause
severe damage to the video tape, and can
lead to internal damage to the camcorder
itself.
CONDENSATION, OPERATION
PAUSED PLEASE WAIT
Appears if condensation occurs. When this
indication is displayed, wait more than 1 hour
until condensation disappears.
Serious malfunctioning
If malfunctioning occurs, stop using the unit
immediately and consult your local JVC
dealer.
The camcorder is a microcomputer-
controlled device. External noise and
interference (from a TV, a radio, etc.) might
prevent it from functioning properly. In such
cases, fi rst disconnect its power supply unit
(battery pack, AC Adapter, etc.) and wait
a few minutes and then re-connect it and
proceed as usual from the beginning.
Changes or modifi cations not approved
by JVC could void the user's authority to
operate the equipment. This equipment has
been tested and found to comply with the
limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses,
and can radiate radio frequency energy
and, if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/
TV technician for help.