Table of Contents
Advertisement
8.3
„Operating" menu
Access the „Operating" menu
B Press the „menu" key for no longer than 3 seconds.
menu
< 3 s
Fig. 19 Accessing the „Operating" menu
Accessing the „Operating" menu provides access to the following modes
of operation:
• manual
• P1
• P2
• P3
• Full
• Off
B Use the „+" or „-" keys to select the desired working mode.
B Confirm using the „oK" key
To go back one menu:
B Press the „menu" key.
-or-
B Do not press any key for the following 15 seconds.
8.3.1 „manual" mode
In this working mode, the device functions 24 hours a day, 7 days a
week, until it reaches a selected temperature. Used heat source is
defined using the Mode function (
Fig. 20 „manual" mode
8.3.2 „P1", „P2" and „P3" modes
„P1" mode
Selecting this menu causes the device to function during the predefined
factory time periods (
„„P1" period„, page 21).
„P2" and „P3" mode
Selecting this menu causes the device to function during user-defined
time periods (
„„P2" and „P3" periods, page 21).
8.3.3 „Full" mode
In this mode, the device uses two heat sources simultaneously: the heat
pump and electrical power.
SUPRAECO W – 6 720 646 161 (2012/04)
-
+
ok
6720646160-14.1V
Chapter 8.5.1) of „Main" menu.
6720646160-37.1V
"Full" mode activation reduces device efficiency, and
should only be selected in the event of need for a rapid
increase in water temperature.
Fig. 21 „Full" mode
This mode permits setting the water temperature anywhere between
30 °C and 70 °C.
Two heat sources are used simultaneously until the
desired temperature is reached.
Only electrical heat is used over 60 °C.
Upon reaching the selected water temperature, the device exits „Full"
mode and returns to the mode previously selected.
8.3.4 „Off" mode
This operating mode disconnects the device. Electrical power is only
activated for the „anti-freeze" protection function, if necessary.
Fig. 22 Modo „Off"
„Anti-freeze" function
The electrical power is connected when the water temperature of the
deposit reaches 5 °C. It is disconnected when the water temperature
reaches 10 °C.
8.4
Setting the DHW temperature
The water temperature is factory-set at a value of 50 °C.
Operation
6720646160-08.1V
6720646160-10.1V
19
Hide quick links:
Advertisement
Table of Contents
