Leds - Devolo MicroLink dLAN Audio User Manual

|
16
Introduction
Resetting the device to the factory default settings
Simultaneously pressing the two function keys ³ and · resets the unit to
the factory default settings. When this is done, all the settings you have
made, such as the channel and operating mode selection, TCP/IP settings or
the assignment of Internet radio stations to specific channels, are reset to the
default values.
Press function keys ³ and · simultaneously. First, all LEDs on the left side
are extinguished; they are then illuminated again in sequence from Channels
1 though 4. Hold down function keys ³ and · until the four channel LEDs
are extinguished again. After the LEDs are extinguished, the MicroLink dLAN
Audio adapter is reset to the factory default settings.
2.4.2

LEDs

The MicroLink dLAN Audio has eight status LEDs:
|
devolo MicroLink dLAN Audio
³
The four green LEDs on the left side of the housing display which channel
is currently being used. The LEDs for 'Channel 1' though 'Channel 4' (from
top to bottom) indicate the current status of the channel using a blink
code:
|
·
»
¿
´